Bloomfield Cooling, Heating & Electric’s Priority Plus Gold Plan

Our Gold Plan maintenance contract gives you $60 per year in Friendly Credits with combined coverage and an annual heating and cooling tune-up for maximum efficiency. Plan members get 50% off diagnostic fees and 15% off repairs.

Our Priority Plus Gold Plan includes:

Master heating tune-up and safety check on the furnace
1. Test carbon monoxide levels.
2. Clean and adjust burners and inspect heat exchanger.
3. Check thermostat operation.
4. Lubricate all motors, bearings, fans and circulator pumps where possible.
5. Clean pilot assembly.
6. Install standard one-inch filters.
7. Test and adjust operation of safety and operating controls
8. Inspect flue pipe and gas valve.
9. Check blower motor (and belt if applicable).
10. Test and tighten all wiring and connections.
11. Turn exposed dampers to heating position if marked
12. Inform customer of equipment condition & recommend necessary repairs.

Hot water boiler check
1. Test carbon monoxide levels.
2. Check thermostat operation.
3. Check electrical connections.
4. Lubricate pump bearings and motors.
5. Clean combustion chamber.
6. Check pilot assembly.
7. Check zone valves.
8. Check all safeties.
9. Check flue pipe and draft.
10. Check expansion tank.
11. Check aquastat/relay.
12. Check water regulator.

Steam boiler
1. Test carbon monoxide levels.
2. Check thermostat operation.
3. Check electrical connections.
4. Clean combustion chamber.
5. Check pilot assembly.
6. Check all safeties.
7. Check flue pipe and draft.
8. Check and drain low-water cutoff.
9. Check gauge glass.
10. Check and adjust water level.
11. Check auto feed (if applicable).

Master cooling tune-up and safety check
1. Lubricate all moving parts, such as blower motor and condenser fan.
2. Check suction line temperature and pressure.
3. Evaluate condition of air filters. Clean or replace with standard 1” filters.
4. Test temperature drop between return and supply air.
5. Flush condensate drain to protect against overflow.
6. Clean the outdoor condenser coil.
7. Check blower motor (and belt if applicable).
8. Adjust blower speed.
9. Safety test on all controls for proper operation.
10. Meter voltage and amperage in all motors. Test for worn bearings.
11. Test operation and condition of compressor contacts.
12. Inspect, start and run capacitors and relays for bulges, rust and leaks.
13. Tighten and safety test all wires and connections.
14. Clean and adjust thermostat/mercury bulb.
15. Inform customer of equipment condition, recommend necessary repairs.